Advertisement
CAUTION:
Besure yourgrill i s
OFF and cool before cleaning.
Take care notto chip or scratchthe painted surfaces
because it willvoid your warranty.
Annual
Cleaning
of The Grill Interior
Burning-offthe grill after every cookout will keep it
ready for instant use. However, once a year you should
give the entire grill a thorough cleaning to keep it in top
operating condition. Follow these steps:
1. Turn all burner valvesto the fuUOFF position.
2. Turn the LPG cylinder valveor NG Shutoff Valve to
the full OFF position.
3. Detach the LPG regulator assembly or NG hose
assembly from your gas grill.
4. Remove and clean the flame tamers, cooking grids
and grill burners.
5. Cover each gas valveorificewith aluminumfoil.
6. Brush the inside and bottomof the grillwith a stiff
wire brush, and wash with a mild soap and warm
water solution.Rinse thoroughlyand let dry.
7. Remove aluminumfoil from orificesand check
each orifice for obstruction.
8. Check each spark electrode, adjustingas needed.
The Electrode tip shouldbe pointingtowardthe
bottomof the gas collector box and approximately
3/16" from the bottom of the collector box.
9. Replace the burnersand adjustthe gas collector
box. The edge of the collector box shouldbe
overlapping the burner port.
10. Replace flame tamers and the cookinggrids.
11. Reconnect the gas sourceand observethe burner
flame for correct operation.
Cleaning Exterior Surfaces:
Before initialuse, and periodically thereafter, we
suggestyou wash your grillusing a mildsoap and
warm water solution.You can use a wash clothor
sponge for this process. Do not use a stiffwire or
brass brushthat mightremove paint dudngthe clean-
ing process.
Cleaning Exterior Stainless Steel Surfaces:
Weathering and extreme heat can cause exterior
stainless steel surfaces to tam tan in color. Follow
these steps for the best cleaning results.
1. Turn the LPG cylinder valve (clockwise) to the full OFF
position. Disconnect the regulator and hose assem-
blyfrom LPG cylinder. Cover exposed gas fitting with
aluminum foil.
2,
Remove dirtor grease using a soft clothand polish
stainless surfaces using a Stainless Steel Foam
Cleaner. Never use abrasivecleanersor scrub-
bers-they will scratch and damage your stainless
steel.
3. Wipe with a soft clothand allowto air dry before
lighting your grill.
WARNING
Do not line the bottom of the grill housing
with aluminum foil, sand or any substance
that will restrict the flow of grease into the
grease draining tray and receptacle.
Failure to comply with these instructions
could result in a fire or explosion which
could cause serious bodily injury, death, or
property damage.
18
Advertisement
