Advertisement
BasicLighting Procedures
1. Familiadze
yourself with the safety guidelinesat
the front of this manual. Do not smoke while
lighting gdll or checking gas supply connections.
2. Be sure the LPG cylinder is filled.
3. Check that the end of each burner tube is propedy
locatedover each valve orifice.
4. Make sure all gas connections are securely
tightened.
5. Open the Grill Lid or Side Burner Insert Plate.
/ WARNING
Failure to open Grill Lid or Insert Plate
during the lighting
procedures could
result in a fire or explosion which could
cause serious bodily injury, death, or
property damage.
6. Set control knobsto OFF and open the LPG
cylinder valve.
7.
Push and turn one cont]'ol knob to HIGH.
8. Then immediately press the electric ignitor for
3-4 seconds to light the burner.
9. If the burnerdoes not light, turnthe control knobto
OFF, wait 5 minutesfor gas to clear, then retry.
10. Once the first gdll burner is ignited,the adjacent
burner can be lit by simply turning it's control knob
to HIGH.
11. Adjust centrol knobs to your desired cooking
temperature.
WARNING
IF YOU SMELL GAS:
• Shut off gas supply to the grill.
• Extinguish any open flame.
• Open grill lid.
• If odor continues, immediately call your
gas company or local fire department.
Failure to comply with these instructions
could result in a fire or explosion which
could cause serious bodily injury, death, or
propertydamage.
Checking
For LP Gas Leaks
Never test for leaks with a flame. Pdor to first
use, at the beginning of each season, or every
time your LPG cylinder is changed, you must
check for gas leaks. Follow these four steps:
1.
2.
3.
4.
Make a soap solution by mixing one part
liquid detergent and one part water.
Turn the grill control knobs to the full OFF
position, then turn the gas ON at source.
Apply the soap solution to all gas
connections. Bubbles will appear in the soap
solution if the connections are not properly
sealed. Tighten or repair as necessary.
If you have a gas leak that you cannot
repair, turn off the gas at the source, discon-
nect fuel line from your grill and call 1-800-4-
MY-HOME or your gas supplier for repair
assistance.
WARNING
A strong gas smell, or the hissing sound of
gas indicates a serious problem with your
gas grill or the LPG cylinder. Failure to
immediately follow the steps listed below
could result in a fire or explosion which
could cause serious bodily injury, death, or
propertydamage.
•
Get away from the LPG cylinder.
•
Do not try to fix the problem yourself.
•
Call your fire department. (Do not call
near the LPG cylinder because your
telephone is an electrical device.)
Lighting Your Grill by Match
To lightyour gas grill by match, follow steps 1 through
6 of the Basic LightingProcedures.Then, insert a lit
match through the lightingholeon either side of the
gdll. See Fig. 14. Tum the nearest control knob to the
HIGH settingto release gas. The burner shouldlight
immediately.
Figure 14
__
LIGHTED MATCH
I
!
!
I
\ LIGHTING
HOLE
WARNING
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and
body a safe distance (at least 18 inches)
from the lighting hole or burners, when
lighting your grill by match.
14
Advertisement
