Advertisement
InstallingSide
Shelf and Side Burner
1. Remove and discard the protective rubber boots
from the Side Shelf and Side Burner braces.
Attach Side Shelf and Side Burner to Cart Legs
as shown in Fig. 9. Align the 4 holes on Side
Shelf and Side Burner frame with the holes on the
Cart Legs. Tighten securely using 4 of the 1/4"x3/
4" Phillips head screws provided.
2. Place a Storage Bin into Side Shelf.
3. Install Connection Tube between the inlet of Gas
Manifold and Brass Adaptor of Gas Valve Assem-
bly as illustrated in Fig. 9.
4. For LPG gas grills: Connect the hose end fitting
of LPG Gas Regulator to the opening end of
Adaptor. Tighten securely with a wrench.
5. For Natural Gas grills:Connect the 12' Natural Gas
Hose between your gas grill, see Fig. 9A and the
natural gas line at your home following
the
instructions included with your natural gas hose.
Also read the natural gas safety instructionsbelow.
6. On both LPG and natural gas grills, connect the
Ignition Wire terminal from Side Burner with the
other from Grill Head. See Fig. 9. Bind the
connected Ignition Wires and Connection Tube
together using the supplied Fastening Band.
Your natural gas grillis designedto operate on
natural gas only, at a pressure of 7"water column
(W.C.) (1/4 psig or 1.75 kpa), regulated at the
residential meter. Check with your gas utility
company for local gas pressure and with your local
municipality for building code requirements. If your
residential gas line pressure has not been regulated
to 7" W.C., contact your local gas utility company
for professional assistance.
It is recommendedthat a ShutoffValve be installedat
the gas supply source outdoors after the gas pipe
exitsthe outsidewalland beforethe quick-disconnect
hose or, beforethe gas line pipingenters the ground.
Pipe sealing compound or pipe thread tape resistant
to the actionof naturalgas must be used on all male
pipe threads when making the connection.
Disconnectyour gas grillfrom fuel sourcewhen the
gas supply is beingtestedat highpressures. This gas
gdll and its individual shutoff valve must be discon-
nected from the gas supply pipe system during any
pressure testing of that system at pressure in excess
of 1/2 psi (3.5kpa).
Turn off your gas grill when the gas supply is being
tested at low pressures. The grill must be isolated
from the gas supply pipe system by closing its
individualmanual shutoffvalve during any pressure
testing of the gas supply pipe system at pressures
equal to or less than 1/2 psi (3.5kpa).
Figure 9
STORAGE BIN
S"
4
.
"
1:::
IGNITION WIRE
=
:.
."
:'_
:
FROM
GRILL
HEAD
-
i_Y
.
.
,J
GNITION WIRE
FROM SIDE BURNER
SIDE
SHELF
/
_..
CART LEGS
--
CONNECTION
TUBE
--_%:
FASTENING
BAND
SIDE BURNER
BRASS ADAPTOR _'_
;_
GAS VALVE /
_'_
a
REGULATOR WITH HOSE
Figure 9A
IGNITION WIRE
::..
FROM GRILL HEAD
:::.
FROM SIDE BURNER
CONNECTION
TUBE
FASTENING
BAND
:; •'_
SIDE BURNER
BRASS ADAPTOR
/
GAS VALVE
N.G. HOSE KIT
,_
INSTRUCTION
TAG
J_
11
Advertisement
