Advertisement
Assembling The Tank Hook and Grill Drawer
1.
Attach the LPG Tank Hook and Tank Holder
to the wheel-side of grill as shown in Fig. 6.
Align the tapped holes of both parts with the
holes on Side Panel. Secure firmly using
1/4"xl/2" Phillips head screws provided.
2.
Install 2 of the 1/4"x1/2" Phillips head screws
to the rear of the Drawer Track.
3.
Slide the Drawer into the Drawer Tracks until
it stops. See Fig. 7.
4.
Install 2 of the 1/4"x1/2" Phillips head screws
to the front of the Drawer Track. This impor-
tant step prevents the drawer from being
pulled outside the tracks. See Fig. 7.
Installing The Grill Head
1.
Now that you've assembled the grill cart you
can install the pre-assembled Grill Head.
See Fig. 8. To reduce the weight of the Grill
Head, we suggest you open the Grill Lid and
remove the packed components. Even with
the components removed, this step requires 2
people to lift and position the Grill Head onto
the grill cart. Be sure to align the 2 holes
beneath the hang ledge on each side of the
Grill Head with the 2 holes on each cross
braces of cart. Raise Grill Lid and insert 4 of
the 1/4"x3/4" Phillips head screws and lock
nuts and tighten securely.
2.
From the back side of grill head, install the
Grease Draining Tray. See Fig. 8.
3.
Center the Grease Receptacle under Grease
Draining Tray. See Fig. 8.
Figure 6
DRAWER TRACK
TANK HOOK
DRAWER
SIDE PANEL
TANK HOLDER
Figure 7
DRAWER TRACK
.... •••,
Figure 8
GRILL HEAD
GREASE RECEPTACLE
CROSS BRACE
GREASE
DRAINING
TRAY
HANG LEDGE
10
Advertisement
