Threading The Machine; Drawing Up Bobbin Thread - Sears Kenmore 385.17628 Owner's Manual

Threading the Machine
o Threading the Machine
'f' Raise the thread take-up lever to its highest
position by turning the handwheel
counterclockwise,
Raise the presser foot lifter,
"; Place a spool on the spool pin, with thread coming
off as shown.
(D Draw the end of thread around the upper thread
guide,,
(_) While holding the thread near the spool, draw the
end of the thread down around the check spring
holder.
(_) Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye,
(_ Slide the thread behind the needle bar thread
guide on the left.
(_) Thread the needle from front to back or use a
needle threader,
We recommend using the convenient needle
threader(#200262101), included with your
machine,,
= Drawing up Bobbin Thread
(_) Raise the presser foot Hold the needle thread
lightly with your left hand and rotate handwhee!
counterclockwise for one complete turn,,
(_) Bring the bobbin thread up by pulling the needle
thread upo
(_ Pull both threads under and to the back of the
presser foot, leaving 4 to 6" (10 to 15cm)
of thread clear°
®
-._t@
26