Toshiba Satellite A130 Maintenance Manual page 155

Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the preceding
section.
1. Seat the display assembly, taking care not to crush to the LCD display cable, the LCD
power cable, the wireless LAN antenna connectors, or the Bluetooth connector.
2. Secure four M2.5x8 black screws to each hinge to connect the assembly to the top cover.
3. Secure two black M2.5x8 black screws to the computer's rear side. They hold the display
assembly in place.
4. Feed the wireless LAN module's antenna wires through the indented track on the system
board towards the rear side.
5. Connect the Bluetooth connector to the Bluetooth module.
6. Connect the LCD power cable to the top chassis.
7. Reinstall the keyboard and wireless LAN module.
Satellite A130/ A135 Maintenance Manual
4 Replacement Procedures
4-37