Pictbridge Printing - Ricoh C220S - Aficio SP Color Laser Administration Manual

Direct Printing from a Digital Camera (PictBridge)

PictBridge Printing

Follow the procedure below to start PictBridge printing on this printer.
Important
❒ Do not disconnect the USB cable while data is being sent. If you do, printing
will fail.
A
Check the printer and the digital camera are both turned on.
B
Connect a USB cable between the USB host interface board installed on the
printer and digital camera.
The Ready indicator on the printer flashes for several seconds and then stays lit.
This indicates the printer recognizes the digital camera as a PictBridge device.
4
C
On your digital camera, select the images you want to print, and then spec-
ify the printing conditions.
D
The printer receives settings from the digital camera and starts printing.
Note
❒ Since printing conditions are specified on the digital camera, specifiable
parameters depend on the digital camera. For details, see the manuals pro-
vided with the digital camera.
❒ Some digital cameras require settings for manual PictBridge operation. For
details, see the manual provided with the digital camera.
❒ Some digital cameras require to turn the power switch off for a manual
PictBridge operation. For details, see the manual provided with the digital
camera.
❒ Some digital cameras need to be switched off when connecting to the print-
er. For details, see the manual provided with the digital camera.
Reference
For details about how to stop printing data, see p.35 "Canceling a Print Job".
44
ASH108S