Ricoh C220S - Aficio SP Color Laser Administration Manual page 128

Status
Multiple pages are fed at once.
Paper gets wrinkles.
The printed paper is curled.
Possible Causes, Descriptions, and Solutions
• There may be a gap between the front end paper guide
and the paper, or between the paper guide both side and
the paper in the paper tray. Make sure there are no gaps.
See p.34 "Loading Paper".
• Paper is either too thick or too thin.
See p.23 "Paper and Other Media".
• Paper has already been printed on.
See p.23 "Paper and Other Media".
• Number of paper set in the tray exceeds the limit. Con-
firm that the top of the stack is not higher than the limit
mark inside the tray.
See p.23 "Paper and Other Media".
• Paper is static. Use paper that has been stored properly.
See p.23 "Paper and Other Media".
• The friction pad, paper feed roller, or registration roller
might be dirty. Clean the relevant component.
See p.66 "Cleaning the Friction Pad and the Paper Feed
Roller" and p.69 "Cleaning the Registration Roller".
• Check that paper was not added while there was still
some left in the tray.
Only add paper when there is none left in the tray.
• Fan the paper before loading.
• Paper is damp. Use paper that has been stored properly.
See p.23 "Paper and Other Media".
• Paper is too thin.
See p.23 "Paper and Other Media".
• There may be a gap between the front end paper guide
and the paper, or between the paper guide both side and
the paper in the paper tray. Make sure there are no gaps.
See p.34 "Loading Paper".
• Load the paper upside down in the paper tray.
• Pull out the extender of the output tray.
• If the paper curl is severe, take prints from the output tray
more frequently.
• Paper is damp. Use paper that has been stored properly.
See p.23 "Paper and Other Media".
• Log on to Smart Organizing Monitor as an Administra-
tor, and then select [Mode 2] or [Mode 3] in the [Anti-humid-
ity:] list on the [System] tab. Note that the first print takes
longer than subsequent prints to complete.
Other Printing Problems
7
83