Switching The Power Off - Xerox DocuPrint C2255 User Manual

Switching the Power Off

Note the following points whenever switching the printer power off.
• When the [LPD Spool] setting is [Memory]
All of the print data spooled in the printer, including data that is currently being printed, is
deleted. The print data is not available when the power is switched back on. However,
print data may be saved on your computer if the power is switched off immediately after
requesting a print job. In this case printing will be performed from the saved print data
when the power is switched back on again, even if a new print job is requested.
• When the [LPD Spool] setting is [Hard Disk]
All of the print data spooled in the printer, including data that is currently being printed, is
saved on the printer's hard disk. Printing will be performed from the saved print data when
the power is switched back on again, even if a new print job is requested.
• When the [LPD Spool] setting is [Off]
All of the print data spooled in the printer receive buffer, including data that is currently
being printed, is deleted. The print data is not available when the power is switched back
on. However, print data may be saved on your computer if the power is switched off
immediately after requesting a print job. In this case printing will be performed from the
saved print data when the power is switched back on again, even if a new print job is
requested.
Printing
• When the [LPD Spool] setting is [Hard Disk] or [Memory]
If the size of the print data is greater than hard disk or memory capacity at the time that
print data receive starts, that print data cannot be received.
Note
• Some computers resend the print data automatically if the size of the print data exceeds the receive
capacity. If this happens, it may appear as if the computer has hung up. To avoid this, cancel sending
print data on the computer.
• When the [LPD Spool] setting is [Off]
While a print request is being received from one computer, a print request from another
computer cannot be received.
• When the computer IP address and computer name are changed
The contact process from the computer and the delete process may not operate correctly
after the computer IP address and/or the computer name is changed. While there is no
print data in the printer's receive buffer, turn the power off and then back on again.
Note
• A control panel operation can be used to cancel or force-eject printing of the print data in the printer's
receive buffer. For information about the procedure you should use, refer to "2.5 Canceling/Checking a
Print Job" (P. 49).
A.11 Notes and Restrictions
301