Wrinkled/Stained Paper - Xerox DocuPrint CM205 b User Manual

Xerox printers user guide
Table of Contents

Advertisement

 Wrinkled/Stained Paper
Problem
The output is wrinkled.
The output is stained.
NOTE:
If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorised dealer.
Action
Verify that the correct print media is being used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 69
• "About Print Media" on page 64
If you use the envelope, check whether the crease is within 30 mm of
the four edges of the envelope.
If the crease is within 30 mm of the four edges of the envelope, this is
considered normal. Your printer is not at fault.
If not, take the following actions:
If the envelope is Envelope #10, which is 220 mm or longer and
has a flap on the long edge, use a different size envelope.
If the envelope is C5, which is 220 mm or longer and has a flap on
the short edge, load it in the MPF with the flap open and facing up.
If the envelope is Monarch or DL, which is shorter than 220 mm,
load it long edge feed in the MPF with the flap open and facing up.
If the problem continues, use a different size envelope.
Troubleshooting
208

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents