Rear Panel - Planet XRT-811 User Manual

Rear Panel

Printer Port
Reset Button
10/100BaseT
LAN connections
WAN port
(10/100BaseT)
Power port
Figure 3: Rear Panel
Standard parallel printer port. If you wish to share a printer, connect it
here.
This button has three (3) functions:
Reboot. When pressed and released, XRT-811 will reboot
(restart).
Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
Ensure the printer is ready.
Both PRINT LEDs will flash simultaneously during the di-
agnostic printing.
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. XRT-811 is now using the factory
default values.
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on XRT-811 will automatically function as an "Up-
link" port when required. Just connect any port to a normal port on
the other hub, using a standard LAN cable.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Connect the supplied power adapter here.
Introduction
5