Macintosh Clients; Linux Clients - Planet XRT-811 User Manual

Internet broadband router
Table of Contents

Advertisement

Macintosh Clients

From your Macintosh, you can access the Internet via XRT-811. The procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field
can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the required changes are:
Set the Router Address field to XRT-811's IP Address.
Ensure your DNS settings are correct.

Linux Clients

To access the Internet via XRT-811, it is only necessary to set XRT-811 as the "Gateway".
Ensure you are logged in as "root" before attempting any changes.
Fixed IP Address
By default, most Unix installations use a fixed IP Address. If you wish to continue using a fixed
IP Address, make the following changes to your configuration.
Set your "Default Gateway" to the IP Address of XRT-811.
Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows shell.
1. Start your X Windows client.
2. Select Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called "eth0".
4. Click the Edit button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
Use the "Deactivate" and "Activate" buttons, if available.
OR, restart your system.
Printing Setup on Linux
XRT-811 supports LPD Printing on Linux.
XRT-811 supports 3 "Logical Printers" under LPD. To configure the "Logical Printers" on
XRT-811, refer to Printer Port in Chapter 7.
The procedure to install a LPD printer is detailed below, but may vary according to your
version of Linux and X -windows shell.
1. In your X Windows shell, select Control Panel, then Printer Configuration.
2. Select Add. For the printer type, select Remote Unix (lpd) Queue.
3. Use the following data to complete the resulting dialog.
PC Configuration
35

Advertisement

Table of Contents
loading

Table of Contents