Table of Contents
Advertisement
XRT-811 User's Manual
LAN Screen
Use the LAN link on the main menu to reach the LAN screen An example screen is shown
below.
Data - LAN Screen
TCP/IP
IP Address
Subnet Mask
DHCP Server
Buttons
Save
Cancel
Figure 6: LAN Screen
IP address for XRT-811, as seen from the local LAN. Use the default
value unless the address is already in use or your LAN is using a
different IP address range. In the latter case, enter an unused IP Ad-
dress from within the range used by your LAN.
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which XRT-811 is attached (the same value as the PCs on
that LAN segment).
If Enabled, XRT-811 will allocate IP Addresses to PCs (DHCP
clients) on your LAN when they start up. The default (and recom-
mended) value is Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-configured to
treat XRT-811 as the default Gateway. See the following section
for further details.
The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Save the data on screen.
The "Cancel" button will discard any data you have entered and reload
the file from XRT-811.
14
Advertisement
Table of Contents
