Configuration Program; Using Your Web Browser - Planet XRT-811 User Manual

Configuration Program

XRT-811 contains an HTTP server. This enables you to connect to it, and configure it, using
your Web Browser. Your Browser must support JavaScript. The configuration program has
been tested on the following browsers:
Netscape V4.08 or later
Internet Explorer V4 or later
Preparation
Before attempting to configure XRT-811, please ensure that:
Your PC can establish a physical connection to XRT-811. The PC and XRT-811 must be
directly connected (using the Hub ports on XRT-811) or on the same LAN segment.
XRT-811 must be installed and powered ON.
If XRT-811's default IP Address (192.168.0.1) is already used by another device, the other
device must be turned OFF until XRT-811 is allocated a new IP Address during configura-
tion.
Using UPnP
If your Windows system supports UPnP, an icon for XRT-811 will appear in the system tray,
notifying you that a new network device has been found, and offering to create a new desktop
shortcut to the newly-discovered device.
Unless you intend to change the IP Address of XRT-811, you can accept the desktop
shortcut.
Whether you accept the desktop shortcut or not, you can always find UPnP devices in My
Network Places (previously called Network Neighborhood).
Double - click the icon for XRT-811 (either on the Desktop, or in My Network Places) to
start the configuration. Refer to the following section for details of the initial configuration
process.

Using your Web Browser

To establish a connection from your PC to XRT-811:
1. After installing XRT-811 in your LAN, start your PC. If your PC is already running, restart
it.
2. Start your WEB browser.
3. In the Address box, enter "HTTP://" and the IP Address of XRT-811, as in this example,
which uses XRT-811's default IP Address:
HTTP://192.168.0.1
Setup
9