Table of Contents
Advertisement
S
A
D V A N C E D
D V A N C E D
D V A N C E D
DSPC
The DSPC (Digital Studio Picture Control)
system checks the condition of the tape in use
during recording and playback, and compensates
to provide the highest possible recording and
playback pictures. The default setting for both
recording and playback is "ON".
1 Press VCR.
2 Press MENU.
3 Press 5 or ∞ select "VCR SET UP" then
press OK/STATUS.
4 Press 5 or ∞ to select "DSPC", then press 3
to set to "ON" or "OFF".
\ DSPC
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
POWER SAVE
AUTO SAT
RECORD LINK
VIDEO STABILIZER
NEXT PAGE
SELECT : 5∞
END : MENU
5 Press MENU.
Once the "DSPC" mode is set to "ON", the
DSPC system works for both recording &
playback, as described below;
For Recording
Press REC/OTR ¶.
DURING DSPC
DSPC COMPLETED
• The VCR spends approximately 7 seconds
assessing the condition of the tape, then begins
recording.
O
P E R A T I O N S
P E R A T I O N S
P E R A T I O N S
ON
ON
ON
OFF
OFF
OFF
OFF
CHANGE : >
Notes:
• The DSPC system works for SP, LP and EP
modes only after a tape has been inserted
and the Record mode is first initiated. It does
not work during recording.
• The DSPC system does not work while Auto
Satellite Prog recording is in progress
(✈P.38).
• In the case of timer recording, the DSPC
system works before recording is initiated.
• Once the cassette is ejected, the DSPC data
is cancelled. The next time the cassette is
used for recording, DSPC is re-performed.
• When "DSPC" is displayed, the VCR does
not start One Touch Recording (✈P.36).
• Since the DSPC system works before
recording actually starts, there is a delay of
approximately 7 seconds after REC/OTR ¶
is pressed. To make sure you record the
desired scene or programme in its entirety,
first perform the following steps:
1) Press and hold PAUSE/STILL 8 on the
front panel and press REC/OTR ¶ on the
front panel to engage the RECORD
PAUSE mode.
• The VCR then automatically checks the
condition of the tape and, after approxi-
mately 7 seconds, re-enters RECORD
PAUSE.
2) Press REC/OTR ¶ to start recording.
• If you want to bypass the DSPC system
and begin recording immediately, set
"DSPC" to "OFF".
For Playback
Press PLAY 3.
• The VCR adjusts the playback picture quality
based on the quality of the tape in use.
• DSPC is active during Auto Tracking.
"DSPC" appears blinking on the front panel's
display window.
Notes:
• When watching a tape recorded with "DSPC"
set to "ON", it is recommended that you leave
DSPC to "ON" during playback as well.
• "DSPC" only appears at the beginning of
automatic tracking. Even though it doesn't
appear after that, the DSPC function is
operative.
—
—
34
( C
( C
) )
( C
)
O N T I N U E D
O N T I N U E D
O N T I N U E D
Hide quick links:
Advertisement
Table of Contents
