Philips VR1200/02 User Manual page 10

S
Do NOT press any button on the front panel or
remote control until the display window shows
either the display as illustrated in step 2 or "- -
: - -".
2 2 2 2 2
If the correct current time is displayed on
the display window, the Auto Channel Set
and Clock Set have been completed
successfully. Go to step 3.
If "1" (channel position) is displayed on the
display window, the Auto Clock Set has not
completed (only the Auto Channel Set has).
Go to step 3 and then perform "Clock
Setting" manually. (✈P.20)
• You can check if the Guide Channel
numbers have been set correctly when you
perform S V
HOW IEW
(✈P.27); if the correct channel position
number is displayed on S
Programme screen, this confirms that the
Guide Channel number for the S
number you enter has been set correctly.
3 3 3 3 3 Press PROGRAMME 5/∞ on the front panel
(or CH 5/∞ on the remote control) to make
sure that all necessary stations have been
stored in the VCR's memory.
• If station names (ID) (✈P.19) have also been
stored in the VCR's memory, the station
name will be displayed at the top left corner
of the screen for about 5 seconds when the
VCR is tuned to a different station.
• If you want to set the tuner manually such
as to add or skip channels, to change
channel positions, or to set station names,
see pages 16-18.
• If no station is stored in the VCR's memory,
make sure the TV antenna cable is con-
nected correctly and turn off the VCR
power once, then turn it back on again. Re-
perform from Preparation on page 9.
Timer Recording
V
HOW IEW
V
HOW IEW
—
Notes:
• Auto channel set function takes place first; it
automatically assigns all receivable stations
in your area.
• Auto clock set function sets the clock auto-
matically by reading the clock setting data
from a station transmitting a PDC signal
while auto channel set is being performed.
• During auto channel set, the VCR recognizes
each station name of the detected stations and
stores them in the VCR's memory, then
automatically sets S
assigned Guide Channel number for those
stations according to the broadcast area.
• In the area where no station TV transmits a
PDC signal, the VCR can perform neither
auto clock set nor auto Guide Channel
number set.
• If there is a power cut, or if you press
STANDBY/ON , POWER or MENU while
Auto Set Up is in progress, Auto Set Up will
be interrupted; be sure to turn off the VCR
power once and try again from step 1.
• Auto clock may not function properly
depending on the reception condition.
—
11
V system's
HOW IEW
To be continued on next page