Philips VR1200/02 User Manual page 12

S
FOLLOW TV
PLEASE WAIT
END : MENU
GUIDE CH. SET
PLEASE WAIT
END : MENU
Do NOT press any button on the front panel or
remote control until display window shows either
the display as illustrated in step 2 or "– –:– –".
2
If the correct current time is
displayed on the display
window, the Auto Channel
Set and Clock Set have
been completed success-
fully. Go to step 3.
If "1" (channel position) is displayed on the
display window, the Auto Clock Set has not
completed (only the Auto Channel Set has).
Go to step 3 and then perform "Clock
Setting" manually. (✈P.20)
• You can check if the Guide Channel
numbers have been set correctly when you
perform S V
HOW IEW
(✈P.27); if the correct channel position
number is displayed on S
gramme screen, this confirms that the Guide
Channel number for the S
you enter has been set correctly.
3 Press PROGRAMME 5/∞ on the front panel
(or CH 5/∞ on the remote control) to make
sure that all necessary stations have been
stored in the VCR's memory.
Timer Recording
V Pro-
HOW IEW
V number
HOW IEW
—
• If station names (ID)(✈P.19) have also been
stored in the VCR's memory, the station
name will be displayed at the top left corner
of the screen for about 5 seconds when the
VCR is tuned to a different station.
• If you want to set the tuner manually such
as to add or skip channels, to change
channel positions, or to set or station names,
see pages 16–18.
• If no station is stored in the VCR's memory,
make sure the SCART cable is connected
correctly and press OK/STATUS to re-
perform Follow TV.
Notes:
• In the area where no TV station transmits a
PDC signal, the VCR can perform neither
auto clock set nor auto Guide Channel
number set.
• If there is a power cut, or if you press
STANDBY/ON, POWER or MENU while
downloading or set up is on progress, it will
be interrupted; be sure to turn off the VCR
power once and try again from the begin-
ning.
• Auto clock may not function properly
depending on the reception condition.
• When you perform Follow TV function, be
sure to use fullywired 21-pin SCART cable.
• On this VCR, the characters available for
station's name (ID) are A-Z, 0-9), -, ∗, + and
(space). Some downloaded station's name
may differ from those of your TV ( ✈ P.19).
IMPORTANT
• In certain reception conditions, station names
may not be stored correctly, and auto Guide
Channel Number Set may not work properly.
If the Guide Channel numbers are not set
properly, when you timer-record a TV
programme using the S
VCR will record a TV programme of a
different station. When programming the timer
using the S V
HOW
whether the channel position on which your
VCR receives the broadcasting station you
wish to record is selected. (✈P.27)
—
13
V system, the
HOW IEW
system, be sure to check
IEW