Using The Gprs Dial Command Atd - Siemens MC35 Command Set

AT Command Set

6.5 Using the GPRS dial command ATD

In addition to the GPRS AT Commands you can use the "D" command to dial into to the GPRS net-
work.
There are two GPRS Service Codes for the ATD Command: Values 98 and 99.
Examples:
ATD*99#
CONNECT
ATD*99*123.124.125.126*PPP*1#
CONNECT
ATD*99**PPP#
CONNECT
ATD*99***1#
CONNECT
ATD*99**PPP*1#
CONNECT
ATD*98#
CONNECT
ATD*98*1#
CONNECT
MC35_ATC_01_V05.00
// establish a connection by service code 99
// establish a connection by service code 99, IP address 123...
//and L2P = PPP and using CID 1.
// The CID has to be defined by AT+CGDCONT
// establish a connection by service code 99 and L2P = PPP
// establish a connection by service code 99 and using CID 1
// establish a connection by service code 99 and L2P = PPP and
// using CID 1. The CID has to be defined by AT+CGDCONT
// establish an IP connection by service code 98
// establish an IP connection by service code 98 using CID 1
// The CID has to be defined by AT+CGDCONT
Page 179 of 256 15.07.2002