AT Command Set
4.25 AT+CMEE Report mobile equipment error
Test command
Response
+CMEE: (list of supported <n>s ) OK
AT+CMEE=?
Parameter
See write command
Read command
Response
+CMEE: <n> OK
AT+CMEE?
Parameter
See write command
Write command
This command controls the presentation of the result codes +CME ERROR:
<err> and CMS:<err> that indicate errors relating to ME functionality.
AT+CMEE=<n>
When you power down or reset the ME with AT+CFUN=1,1 the setting will be re-
set to its default. The levels 1 or 2 need to be selected every time you reboot the
ME, or may be included, for permanent use, in the user profile saved with AT&W.
Response
OK
Parameter
<n>
Example
To obtain enhanced error messages it is recommended to choose <n>=2.
AT+CMEE=2
OK
Reference
Note
· The possible error result codes are listed in chapter 9
GSM 07.07
· In multiplex mode (see "AT+CMUX Enter multiplex mode", pg. 101) the set-
MC35_ATC_01_V05.00
0 disable result code (only 'ERROR' will be displayed)
1 enable result code and use numeric values
2 enable result code and use verbose values
ting applies only to the logical channel where selected. The setting on the
other channels may differ.
Page 97 of 256
15.07.2002