Paper Sizing And Print Speed - Xerox DocuPrint 100 Installation Planning Manual

Paper sizing and print speed

Installation Planning Guide
• Transparencies: Must be the type designed for high-speed
printers and must meet the specifications described in the
section above. Loading instructions are printed on all paper
trays.
Load transparencies with the opaque strip to the right. All
printed transparencies are delivered to the sample tray.
As long as they meet your printer's paper specifications, you
can also use:
• Tinted paper: Available in a variety of colors, it has many
uses, including calling attention to certain printed material,
separating special sections, or dividing chapters of a report.
• Preprinted paper: May be letterhead, forms, or logos.
• Predrilled paper: Has a varying number of holes for use in
binders or binder rings. Before loading predrilled paper, fan it
to remove loose plugs that could cause paper jams. Load
predrilled paper in the printer with holes to the right.
• Perforated paper
• Pre-cut or full tabs
• Carbonless paper
NOTE: The printer can print on precollated or ordered stocks,
including ordered tabs. However, jam recovery is not supported
with these stocks.
The printer paper trays have edge guide sensors that detect
paper length and width. The system selects correct paper trays
for the print job based on the paper size specified in the job, as
follows:
• If an exact match is found, the print job continues.
• If an exact match is not found, the programmer can specify in
the job for the printer to either:
– Stop printing the job and print an error sheet
– Print the data on an oversized sheet.
If you encounter any problems related to paper sizing, contact
your lead operator, systems specialist, or service representative.
Supplies
A-3