Table of Contents
Advertisement
Creating and configuring a DHCP Scope (Windows 2000)
Use the following procedure to create and configure a DHCP scope (Windows 2000):
1. Select Start >Programs >Administrative Tools>DHCP.
2. In the console tree, click the DHCP server to which you want to add the DHCP scope for the
IP Telephones. This is usually the name of your DHCP server.
3. Select Action>New Scope from the menu.
Windows displays the New Scope wizard to guide you through rest of the setup.
4. Click Next.
The Scope Name dialog box is displayed.
5. Enter a name for the scope in the Name field.
6. Enter a brief comment in the Description field.
7. Click Next when finished.
The IP Address Range dialog box is displayed.
8. Define the range of IP addresses used by the IP Telephones.
The Start IP Address should be the first IP address available to the IP Telephones. The End
IP Address should be the last IP address available to the IP Telephones.
9. Define the subnet mask in one of two ways:
The number of bits of an IP address to use for the network/subnet IDs
The subnet mask IP address in dotted-quad notation
Enter only one of these values.
10. Click Next when finished.
The Add Exclusions dialog box is displayed.
11. Exclude any IP addresses in the range specified in the previous step that you do not want to
be assigned to an IP Telephone.
a. Enter the first IP address in the range that you want to exclude in the Start Address field
under Exclusion Range.
b. Enter the last IP address in the range that you want like to exclude in the End Address
field under Exclusion Range.
c. Click the Add button.
d. Repeat steps a. through c. for each IP Address range that you want to exclude.
Issue 3.4.1 June 2005
DHCP
409
Advertisement
Table of Contents
