Table of Contents
Advertisement
Physical type
Line Speed
VLAN Tag insertion
Send SMS if the drops out
Send Mail Alert if line
drops out
Active Mode
Backup Type
W
W
A
A
N
N
3
3
w
w
i
i
t
t
h
h
U
U
S
S
B
B
To use 3G network connection through 3G USB Modem, please configure WAN3 interface.
You can change the physical type for WAN2 or choose
Auto negotiation for determined by the system.
If your choose According to Line Speed as the Load
Balance Mode, please type the line speed for downloading
and uploading for such WAN interface. The unit is kbps.
Enable – Enable the function of VLAN with tag.
The router will add specific VLAN number to all packets
on the WAN while sending them out.
Please type the tag value and specify the priority for the
packets sending by WAN1.
Disable – Disable the function of VLAN with tag.
Tag value – Type the value as the VLAN ID number. The
range is form 0 to 4095.
Priority – Type the packet priority number for such VLAN.
The range is from 0 to 7.
Use the drop down list to choose one of the profiles which
will be used to notify the administrator when the network
connection is off.
Check the box to enable this function. When the network
connection is off, the system will send a mail alert to notify
the administrator.
Choose Always On to make the WAN2 connection being
activated always.
If you choose Backup as the Active Mode, Backup Type
will appear. Please specify which WAN will be treated as
the Backup WAN.
When any WAN disconnect – Such backup WAN will be
activated when any master WAN interface disconnects.
When all WAN disconnect – Such backup WAN will be
activated only when all master WAN interfaces disconnect.
53
Vigor2850 Series User's Guide
Advertisement
Table of Contents
