Table of Contents
Advertisement
Figure 11
AXB-EM232 rear view
Figure 12
Connecting the CC-232 cable
14
Wiring the System
Port 2
Connecting the CC-232 Cable
To connect the CC-232 cable:
Connect the CC-232 cable to Port 2 of the AXB-EM232 as shown in Figure 12.
1.
Connect the other end of the CC-232 cable (DB-9 connector) to the Tandberg
2.
codec Data 2 port as shown in Figure 12.
AXB-EM232 rear
GND
RX2
TX2
Connecting the PS4.2 Power Supply
The PS4.2 is supplied with a 3 foot DC power cord with two-pin captive wire ter-
minal. Connect this cable to the PWR connector on the AXB-EM232 to supply 12
VDC to the unit.
Port 1
Codec
Port 2
Captive
screw
connector
GND
RX2
TX2
VClink Codec Master Control System
AXlink
Power
1
6
RS-232
(DB-9)
9
5
Advertisement
Table of Contents
