Requesting A Still Image; Viewing A Stored Still Image; Far-End Control - AMX Codec Master Control System Instruction Manual

Figure 54
View button on conference
page
70 Operational Quick Guide

Requesting a still image

To request a still image of the current video image being received from the remote
site, press the Request button located in the Still Image section of the CONF and
ECHO CANCEL control screens. When the View button is highlighted, the re-
quested still image is displayed.

Viewing a stored still image

To view the last sent or received still image, press the View button (Figure 54) lo-
cated in the Still Image section on the CONF and ECHO CANCEL control screens.
Press the button again to return to normal view.

Far-End Control

The system supports far-end camera control, source selection, and preset recall for
remote site supporting FECC (H.281). To gain control access of the far-end equip-
ment, select the Far End Sources button located in the Video Source section on the
VClink Codec Master Control System