Figure 9
Preferred rack-mounting
configuration
VClink Codec Master Control System
Installation
Overview
This section explains how to mount your equipment, wire the system, and perform
basic setup configurations on your system hardware.
Mounting the Equipment
Figure 9 illustrates the preferred rack mounting configuration for the codec, AXB-
EM232, and the PS4.2 Power Supply.
Installing the AXB-EM232
To rack-mount the AXB-EM232 with the AC-RK Accessory Rack Kit:
Remove any connected power, AXlink, and communication connectors from
1.
the rear panel of the AXB-EM232.
Remove the two screws on the front panel of the AXB-EM232.
2.
Remove the front panel and the space bracket behind the panel.
3.
Remove the rubber feet on the bottom of the unit. If necessary, insert a scissors
4.
blade or other sharp object into the side of one of the rubber feet and pull it off.
Do the same to remove the other three rubber feet.
Place the unit in the center opening in the AC-RK.
5.
Codec
PS
AXB-EM232
Enhanced
12V
RS232
TX1
RS232/422
TX2
AXl i n k
1
2
P R O G R A M
O N
P R O G R A M
R X 1
R X 2
4.2
D C
PS4.2 Power Supply
AXB-EM232
Installation
11