Table of Contents
Advertisement
Figure 55
Far End Camera Control
page
VClink Codec Master Control System
CONF, DIAL, MCU, and ECHO CANCEL control screens. Select Far End Control to
see the following Far End Control page (Figure 55).
To change sources at the remote end, select any of the five sources indicated under
the Video Source section. If the quantity of remote camera sources is greater than 5,
select the appropriate Video Group. If the remote site is using pan/tilt cameras, the
following features are available:
Zoom In/Out
Focus +/-
Pan Left/Right
Tilt Up/Down
If the remote end has stored camera presets, these are remotely recalled by pressing
the buttons 1 through 4 located in the Camera Presets section.
Operational Quick Guide
71
Advertisement
Table of Contents
