AMX NetLinx Studio Instruction Manual page 180

Diagnostics Menu Options
FIG. 246 NetLinx Notifications Properties - [Add] dialog
3.
Specify the Device, Port and System numbers for the NetLinx device that you want to set notification options for.
4.
Check each notification type that you want to enable for that device.


5.
Click OK to close the NetLinx Notification Properties (Add) dialog and return to the NetLinx Device Notifications
Options dialog.
The new target device specified has its own line in the notifications list. The Device:Port:System values (for
example, 1:0:0) identify the device in the Device column. The selected notification option(s) are labeled as ON in
the associated column(s).
FIG. 247 NetLinx Notifications Properties - [Add] dialog
6.
Repeat steps 2-5 to configure NetLinx Notifications for as many additional devices as is necessary.
7.
Select Enable Asynchronous Notifications to enable/disable NetLinx asynchronous notification messages being
sent by the master controller. These are low-level strings of raw data, used primarily for troubleshooting the
NetLinx master. This option is intended for use in conjunction with AMX Technical Support.
8.
Click Done to save changes and close the dialog.
168
To set the selected set of notifications as the default notifications for this device, click the Set As Defaults
button.
Once you set the default notifications, you can use the Use Defaults button to recall the default set.
NetLinx Studio - Instruction Manual