Tools Menu Options; Overview; Reboot The Master Controller - AMX NetLinx Studio Instruction Manual

Tools Menu Options

Overview

This section describes the options presented in the Tools menu. Note that the first two options in this menu (File
Transfers and Firmware Transfers are covered in the File Transfer Operations section on page 149:


Also, see the Working with Online Devices section on page 137 for details on using the Terminal Session and Telnet
Session options:


Reboot the Master Controller

Select Tools > Reboot the Master Controller to access the Reboot the Master Controller dialog. Use the options in this
dialog to reboot a specified master controller (FIG. 271).
FIG. 271 Reboot the Master Controller dialog
The left side of this dialog lists the Projects and Systems that are included in the currently open Workspace. By default,
the currently active System is highlighted. The Master specified in the active (highlighted) System is the one that will be
rebooted.
1.
Click on any other System to select a different Master to reboot.
2.
Once the desired System has been selected (highlighted), click the Reboot button to reboot the Master associated
with the selected System.



3.
Click Done to close this dialog.
NetLinx Studio - Instruction Manual
See File Transfer Operations on page 149.
See Firmware Transfers on page 163.
See Terminal and Telnet Sessions on page 145.
All communications to the Master are stopped in order to activate a connection and initiate the reboot process.
Allow 20-30 seconds for the reboot.
You can reboot more than one Master before closing this dialog.
Tools Menu Options
185