Valid Subnet Masks; Set Identification Mode - AMX NetLinx Studio Instruction Manual

Refer to Valid Subnet Masks on page 181 for a listing of valid Subnet Masks and the
maximum number of IP Hosts allowed for each.
6.
To specify the DNS Addressing information for the selected device: click in the Change DNS Addressing check
box to enable the Domain Suffix and DNS IP #1 - #3 options.
7.
Click Done to apply the device address information from this dialog to the selected Device.

Valid Subnet Masks

The following table lists valid Subnet Masks and the maximum number of IP Hosts allowed for each:
Valid Subnet Masks
Subnet Masks
255.255.255.255
255.255.255.254
255.255.255.252
255.255.255.248
255.255.255.240
255.255.255.224
255.255.255.192
255.255.255.128

Set Identification Mode

The options in the Set Identification Mode tab of the Network Device Addressing dialog allow you to use ID Mode to
identify Network Devices that are located throughout a system, and change their device addressing information if
necessary (FIG. 262).
FIG. 262 Network Device Addressing dialog - Set Identification Mode tab
NetLinx Studio - Instruction Manual
Max IP Hosts Subnet Masks
1 255.255.255.0
2 255.255.254.0
4 255.255.252.0
8 255.255.248.0
16 255.255.240.0
32 255.255.224.0
64 255.255.192.0
128 255.255.128.0
Max IP Hosts Subnet Masks Max IP Hosts
256 255.255.0.0
512 255.254.0.0
1024 255.252.0.0
2048 255.248.0.0
4096 255.240.0.0 1048576
8192 255.224.0.0 2097152
16384 255.192.0.0 4194304
32768 255.128.0.0 8388608
Diagnostics Menu Options
Subnet Masks Max IP Hosts
65536 255.0.0.0 16777216
131072
262144
524288
181