Uploading Firmware And Configuration Files; Firmware File Upload; Figure 10-13 Telnet Into Menu 24.7.1 - Upload System Firmware - ZyXEL Communications Prestige 316 User Manual

10.4 Uploading Firmware and Configuration Files

This section shows you how to upload firmware and configuration files. You can upload configuration files
by following the procedure in the previous Restore Configuration section or by following the instructions in
Menu 24.7.2 - System Maintenance - Upload Router Configuration File (for console port).
DO NOT INTERUPT THE FILE TRANSFER PROCESS AS THIS MAY

10.4.1 Firmware File Upload

FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Figure 10-13 Telnet Into Menu 24.7.1 — Upload System Firmware
Firmware and Configuration Maintenance
Prestige 316 Broadband Sharing Gateway/Wireless LAN
WARNING!
PERMANENTLY DAMAGE YOUR PRESTIGE.
Press ENTER to Exit:
10-11