Table of Contents
Advertisement
Prestige 316 Broadband Sharing Gateway/Wireless LAN
10.4.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation, which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Figure 10-14 Telnet Into Menu 24.7.2 — System Maintenance
To upload the firmware and the configuration file, follow these examples:
10.4.3 FTP File Upload Command from the DOS Prompt Example
Step 1.
Launch the FTP client on your computer.
Step 2.
Enter "open", followed by a space and the IP address of your Prestige.
Step 3.
Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6.
Use "put" to transfer files from the computer to the Prestige, for example, put firmware.bin ras
transfers the firmware on your computer (firmware.bin) to the Prestige and renames it "ras".
Similarly put config.rom rom-0 transfers the configuration file on your computer (config.rom) to
the Prestige and renames it "rom-0". Likewise get rom-0 config.rom transfers the configuration
10-12
Press ENTER to Exit:
Firmware and Configuration Maintenance
Advertisement
Table of Contents
Troubleshooting
