Table of Contents
Advertisement
The next table gives you instructions about configuring remote node network layer options.
Table 4-3 Remote Node Network Layer Options Menu Fields
FIELD
If your ISP did not assign you an explicit IP address, select Dynamic;
IP Address
Assignment
otherwise select Static and enter the IP address and subnet mask in
the following fields.
IP Address
If you have a Static IP Assignment, enter the IP address assigned to
you by your ISP.
IP Subnet Mask
If you have a Static IP Assignment, enter the subnet mask assigned
to you.
Gateway IP Addr
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
Network Address
Use [SPACE BAR] to toggle between Full Feature, SUA Only and
Translation
None. See a previous section for a full discussion of this feature.
Metric
The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. Enter a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number. This field is N/A if Encapsulation field is Ethernet.
Private
This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts. This field is N/A if Encapsulation field is Ethernet
Press [SPACE BAR] to select the RIP direction from Both/None/In
RIP Direction
Only /Out Only. Please see a previous section for more information
on RIP. The default for RIP on the WAN side is None. It is
recommended you do not change this setting.
Version
Press [SPACE BAR] to select the RIP version from RIP-1/RIP-2B/RIP-
2M and N/A.
Multicast
Turn on/off IGMP support and select the version from IGMP-v2/ IGMP-
v1/None.
Once you have completed filling in the Remote Node Network Layer Options menu, press [ENTER] to
return to Menu 11. Press [ENTER] at the message "Press ENTER to Confirm..." to save your
configuration, or press [ESC] at any time to cancel.
Remote Node Setup
Prestige 316 Broadband Sharing Gateway/Wireless LAN
DESCRIPTION
EXAMPLE
Dynamic
Full
Feature
3
Yes
.
None
RIP-2B
None
4-7
Advertisement
Table of Contents
Troubleshooting
