Uploading A Firmware File Via Console Port; Example Xmodem Firmware Upload Using Hyperterminal; Figure 5-16 Menu 24.7.1 As Seen Using The Console Port; Figure 5-17 Example Xmodem Upload - ZyXEL Communications Prestige 724 User Manual

Prestige 724 G.SHDSL CSU/DSU

5.4.7 Uploading a Firmware File Via Console Port

Step 1. Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.1 -
System Maintenance - Upload System Firmware, then follow the instructions as shown in the
following screen.
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart the
Warning: Proceeding with the upload will erase the current router
firmware.
Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.

5.4.8 Example Xmodem Firmware Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.
5-14
Menu 24.7.1 - System Maintenance - Upload System Firmware
Xmodem upload on your terminal.
system.
Do You Wish To Proceed:(Y/N)

Figure 5-16 Menu 24.7.1 as seen using the Console Port

Figure 5-17 Example Xmodem Upload

Type the firmware file's
location, or click
Browse to look for it.
Choose the Xmodem
protocol.
Then click Send.
Firmware and Configuration File Maintenance