Remote Management - ZyXEL Communications Prestige 724 User Manual

Prestige 724 G.SHDSL CSU/DSU
FIELD
Encapsulation Press [SPACE BAR] to select the type of encapsulation you require.
If you are unsure of this information contact your NSP. Options are:
FRF8_TRANSLATION, FRF8_TRANSPARENT,
ENCAP_HDLC_RFC2364, FRF.5 or PPP.
Note: If you choose FRF.5 and wish to map multiple DLCIs then you
must use one channel for each DLCI. You must use the same
VPI/VCI for every DLCI mapped.
Note: Do not select PPP unless you want to configure remote
management. See section 3.4 for more
VPI Enter the VPI (Virtual Path Identifier) that your NSP gives you. The
range of the VPI is 0-255.
VCI Enter the VCI (Virtual Channel Identifier) that your NSP gives you.
The range of the VPI is 32-65535.
DLCI Enter the DLCI. Get this information from the device attached to the
Prestige LAN port. The range of the DLCI is 16-991.
When the Encapsulation field is ENCAP_HDLC_RFC2364 or PPP
then this field is N/A.
Outgoing:
My Login These fields are N/A unless you select PPP and therefore wish to
configure remote management. If this is the case, refer to section 3.4
My Password
for more information.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
3.4

Remote Management

Remote management provides a dedicated channel that allows the Prestige to get the WAN IP address from
your NSP.
The channel dedicated to remote management is not capable of data transfer.
Perform initial configuration of the remote management channel locally. To configure a channel for remote
management, enter 11 from the main menu and then enter a channel number to display Menu 11.1 –
Channel Profile, shown next. The channel number you select in menu 11 will determine which channel
will be used for remote management.
3-6
DESCRIPTION
information.
EXAMPLE
FRF8_TRANS
LATION
(default)
8
(default)
35
(default)
N/A
N/A
N/A
Channel Setup