Hardware Installation and Initial Setup
This chapter shows how to make connections and set up your DSL connection using the SMT.
2.1
Installation Requirements
In addition to your Prestige package, your computer should have the following hardware and software:
•
A console port (to establish a connection to the Prestige).
•
Communications software configured as follows: VT100 terminal emulation; 9600 baud; no parity,
8 data bits, 1 stop bit, no flow control.
2.2
Front Panel LEDs of the Prestige 724
The LED indicators on the front panel show the operational status of the Prestige.
LED
COLOR
PWR
Green
SYS
Green
DATA
ACT
Green
LNK
Green
Hardware Installation and Initial Setup
Figure 2-1 Front Panel of Prestige 724
Table 2-1 LED Functions
STATUS
On
The Prestige is receiving power.
On
The Prestige is on and functioning properly.
Blinking
The system is rebooting or running self-diagnostics.
Off
The Prestige is not ready, has a malfunction or is off.
Off
The data port is not transmitting or receiving data.
Blinking
The data port is transmitting or receiving data.
On
The link is up.
Prestige 724 G.SHDSL CSU/DSU
Chapter 2
DESCRIPTION
2-1