Table of Contents
Advertisement
Prestige 724 G.SHDSL CSU/DSU
xDSL
1.
Reset xDSL
Figure 4-8 Menu 24.4 — System Maintenance — Diagnostic
The following table describes the diagnostic tests available in menu 24.4.
FIELD
Reset xDSL
Reboot System
Command Mode
4.5
Command Interpreter Mode
This mode is for debugging purposes only. Do not use the Command Interpreter
Mode unless instructed to do so by a qualified service technician.
The Command Interpreter (CI) is a part of the main Prestige firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. The CI can be entered
from the SMT by selecting menu 24.8. Access can be either by Telnet or by a serial connection to the console
port, although some commands are only available with a serial connection.
Enter 8 from Menu 24 - System Maintenance. A list of valid commands can be found by typing "help" or
"?" at the command prompt. Type "exit" to return to the SMT main menu when finished.
4-6
Menu 24.4 - System Maintenance – Diagnostic
Enter Menu Selection Number:
Table 4-3 System Maintenance Menu — Diagnostic
Type 1 to re-initialize the xDSL link to the telephone company.
Type 21 to reboot the Prestige.
Type 22 to enter the mode to test and diagnose your Prestige using specified
commands. This mode is the same as the Command Interpreter Mode (described
next).
System
21. Reboot System
22. Command Mode
DESCRIPTION
System Information & Diagnosis
Advertisement
Table of Contents
