Traffic Generator Setup Display - Fluke Series II User Manual

OneTouch Series II
Users Manual
1
2
3
4
5
6
Figure 7-9. Traffic Generator Setup Display
7-16
1. Rate indicates the current Traffic Generator bit rate
excluding the Ethernet overhead of preamble and
inter-frame gap.
2. Use the arrow icons to set the number of frames
transmitted per second.
3. Use the arrow icons to set the frame length.
4. Select the Frame Type as MAC (Media Access
Control), IP, or PING. Refer to the following sections
on Traffic Generator modes for more information.
5. Select Broadcast (only available for a Frame Type
of MAC) to transmit traffic as broadcast or do not
select it to transmit traffic as unicast.
If you selected a Frame Type of IP or PING, the
Broadcast selection changes to Target IP Address
allowing you to specify an IP address by pressing the
box and then entering the address from the displayed
keypad.
6. Press
Press
Generator.
ce707f.eps
(Start Traffic) to start generating traffic.
(Stop Traffic) to stop the Traffic