Entering Ipx Addresses - Fluke Series II User Manual

Press IP Ping or NetWare Ping as appropriate.

Entering IPX Addresses

From the Connectivity Tests display, press
NetWare Ping), then press the (NetWare Ping) tab to
access the NetWare Ping Configuration display (Figure 6-
4).
Figure 6-4. NetWare Ping
The NetWare ping test requires only the IPX node
address of the station you want to ping. If you want the
Network Assistant to find the station's network address,
enter 00000000 as the network address. Press an
(IP &
address box to access the keypad for entering IPX
addresses.
ace605s.bmp
Connectivity Tests
Introduction
Figure 6-5. IP Ping
6
ace604s.bmp
6-3