Fluke Series II User Manual page 52

The Wiremap Cable test can be run as a standalone test
or automatically when you run Cable Autotest or AutoTest.
The standalone test and Cable Autotest are run under
Cable Tests.
To run a standalone test Wiremap Cable test, attach the
cable to the Network Assistant and a remote unit to the far
end of the cable under test, then press
Cable). Figure 4-2 shows an example of the Wiremap
Cable test results.
(Wiremap
If the Wiremap Cable test is conducted as part of the
Cable Autotest or AutoTest, and if the Wiremap Cable test
cannot run completely due to poor cable termination or
quality, the Network Assistant displays a message
recommending that you run the standalone version of the
test to obtain additional error information.
Cable Tests
Figure 4-2. Wiremap Results
4
Introduction
ace402s.bmp
4-3