Fluke Series II User Manual page 94

1.
Remote IP Enter the source IP address of the
Address Network Assistant at the remote end
by pressing the Remote IP Address
box. For xDSL, enter the Target IP
ATU-C Address. Enter the address
with the keypad then press
2. Enables you to enter the IP address for
the local (this) unit. Select the method
IP Config
for configuring the IP Address (Manual
or DHCP). See Chapters 2 and 6 for
more information.
3. Select 2, 10, 30, 60, 120 or 300
seconds, 1 hr, 12 hrs, or 18hrs as the
Duration
duration of the test.
Select to send all zeros (All 0s), all
4.
ones (All 1s), alternating ones and
Data PRBS
zeros (Alt 1/0), or a Pseudo-Random
Bit Sequence (PRBS). The PRBS
pattern simulates normal data traffic.
5.
Speed
.
ITO – Internetwork Throughput Option
Select from the following upstream (to
remote unit or central office for xDSL)
and downstream (from remote unit)
speeds to be tested:
ITO Speed Parameters
q
ISDN 128 Kbps, T1 1.544 Mbps,
E1 2.048 Mbps, and 1 Mbps/1
Mbps
XDSL Speed Parameters
ANSI Asymmetrical Rates: 64
Kbps/1.5 Mbps, 160 Kbps/3 Mbps,
384 Kbps/4.6 Mbps,
640 Kbps/6 Mbps, 1 Mbps/1
Mbps.
q
Auto: Tests a range of speeds to
determine the operating speed of
RADSL modems. The following
additional icons are displayed:
Select the lowest speed
for the range of
Start at
downstream rates to be
tested.
7
Introduction
7-11