To Perform Long Printing/Cutting - Roland CAMM PRO PC-60 User Manual

3 Loading the Material

To Perform Long Printing/Cutting

When performing printing or cutting over a length of 1.5 m (60") or more, first feed out the required length of material. Then follow the
steps below to load the material.
If the DIP switch (SW-8) has been set to disable the prefeed function, skip steps 6 and 7.
1
Use material that is wider by 50 mm (2") or more than
the width of the printing or cutting to be performed.
3
Position the pinch rollers as shown in the figure.
25 mm
(1")
or more
Material
alignment
stickers
4
Lower the sheet loading levers to secure the
material in place.
6
Feed out the length of material to be printed or cut.
24
Make sure that the material
remains held by the pinch
rollers.
If the material does come
loose from the pinch rollers,
set it in place again.
2
Perform steps 1 through 4 of "3 Loading the
Material".
5
Attach the stoppers to the edges of the roll material
and tighten the screws to secure in place.
Roll material
Stopper retaining screw
7
Return the fed-out material.
25 mm
(1")
or more
Material
alignment
stickers
Make sure the material
lies over the front and
rear sensors.