To Perform Long Printing/Cutting - Roland ColorCAMM PRO PC-600 User Manual

To Perform Long Printing/Cutting

When performing printing or cutting over a length of 1 m (39-3/8 in.) or more, first feed out the required length of material. Then follow
the steps below to load the material.
If the setting for enabling the prefeed function has been made on the PC-600, then skip steps 6 and 7.
Use material that is wider by 50 mm (2 in.) or more
1
than the width of the printing or cutting to be
performed.
3
Position the pinch rollers as shown in the figure.
25 mm
(1 in.)
or more
Material
alignment
stickers
4
Lower the sheet loading levers to secure the material
in place.
6
Feed out the length of material to be printed or cut.
When you are performing long printing, expansion or contraction of the material may cause colors to be misaligned.
For roll material in particular, the time required for the material to uncurl and acclimatize to the ambient temperature
and humidity is different for the outer portions and the central portion of the roll.
Before you perform long printing, pull out the length of material to be printed from the roll and let it allow to stand for
about 30 minutes to an hour to allow it to become acclimatized to the environment, then load the material.
Make sure that the
material remains held by
the pinch rollers.
If the material does come
loose from the pinch
rollers, set it in place
again.
2
Perform steps 1 through 3 of "2-3 Loading the
Material".
5
Attach the stoppers to the edges of the roll material
and tighten the screws to secure in place.
Roll material
Stopper retaining screw
7
Return the fed-out material.
Chapter 2 - Basic Operation
25 mm
(1 in.)
or more
Material
alignment
stickers
Make sure the
material lies over the
front and rear sensors.
29