Controller Connection; Connecting 12-Volt Trigger Output To External Theater Equipment; Connecting 12-Volt Trigger Outputs - Runco Quantum Color Q-750i Series Installation & Operation Manual

Installation
RS-232 Controller
Connection
Connecting 12-Volt
Trigger Output to External
Theater Equipment
Connect a PC or home theater control/automation system (if present) to the RS-232 port
on the Q-750i; see Figure 3-14. Use a standard, 9-pin serial cable, wired straight-through.
For more information about using this connection, refer to Serial Communications on
page 75.
to Automation/Control System or PC
Figure 3-14. RS-232 Control System Connection
If your Q-750i is equipped with a CineWide with AutoScope system, connect the
AutoScope lens motor to a 12-volt trigger output on the projector; see Figure 3-15.
Similarly connect other 12-volt trigger-activated equipment (such as retractable screens or
screen masks) to the other trigger output.
AutoScope Lens Motor
Power
Switch
3.5-mm
mini plug
Retractable Screen or other
12-volt trigger-activated
device
Figure 3-15. Connecting 12-Volt Trigger Outputs
AC Input
Sleeve = Ground
Tip = +12V
34
5 4 3 2 1
9 8 6
7
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
Q-750i Series Installation/Operation Manual