Turning On The Power; Primary Lens Adjustments; Focus And Zoom; Lens Shift - Runco Quantum Color Q-750i Series Installation & Operation Manual

Installation
3.8

Turning on the Power

3.9
Primary Lens
Adjustments

Focus and Zoom

Lens Shift

1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see above).
3. Press the ON button on the remote control to turn on the Q-750i. The LED flashes
green to indicate that it is warming up.
4. When the projector is ready for use, the LED turns off.
The Q-750i gives you a great deal of control over the picture size, position and focus.
To focus the projected image, grasp the lens by the outer ring and rotate it.
To make the picture smaller (zoom out) or larger (zoom in), move the zoom tab in the
appropriate direction.
Q-750i
Zoom
in
To access the lens shift controls, loosen the Phillips screw at the bottom of the decorative
bezel on the front of the projector (see Figure 2-1). Then, remove the bezel.
Vertical Lens Shift: To shift the
projected image vertically, insert
the provided hex wrench into the
vertical lens shift adjuster at the top
of the projector (directly above the
lens). Then, turn the wrench as
shown to shift the lens in the
desired direction.
Horizontal Lens Shift: To shift the
projected image horizontally, insert
the provided hex wrench into the
horizontal lens shift adjuster at the
top of the projector. Then, turn the wrench as shown to shift the lens in the desired
direction.
When you have finished adjusting the lens position, re-install the front bezel.
Zoom
out
Focus
36
Q-750i Ultra
Zoom out
Zoom
in
Horizontal
Lens Shift
Q-750i Series Installation/Operation Manual
Focus
Vertical
Lens Shift
L