Runco Quantum Color Q-750i Series Installation & Operation Manual page 82

Operation
PIP Position: To change the position of the PIP image, choose PIP Position from the
System menu; see Figure 4-15. Choose one of the following:
• Top Left: This places the PIP source into a 644x362 designated image area at the top
left of the screen.
• Top Right: This places the PIP source into a 644x362 designated image area at the
top right of the screen.
• Bottom Left: This places the PIP source into a 644x362 designated image area at the
bottom left of the screen-safe area of the DMD.
• Bottom Right: This places the PIP source into a 644x362 designated image area at
the bottom right of the screen-safe area of the DMD.
• Picture-By-Picture: This reduces the designated image area of the Active source to
921x518 and places it next to the PIP source, which is also in a 921x518 image area.
These two images are centered on the screen.
• Split Screen: This is a special mode in which the active source is also used as the PIP
source and placed in a PIP area equal to half the display on the left side. This results in
the right half of the image being the active source and the left half is the PIP source.
The Q-750i applies the Custom 2 settings to the PIP image.
Split-screen mode is useful for viewing "before" and "after" settings for Sharpness,
Noise Reduction and other advanced image parameters. See Figure 4-16.
DMD Area 1920x1080
921x518
PBP1
Figure 4-15. PIP and PBP areas for 1080p Display
921x518
66
644x362
PIP
(top right)
PBP2
Screen-Safe Area 1842x1036
Q-750i Series Installation/Operation Manual