Runco Quantum Color Q-750i Series Installation & Operation Manual page 37

10. Install the two (2), black plastic retaining clips (also provided with the lens) on either
side of the lens cavity. Each clip is held in place with two (2), captive Phillips screws.
The white, plastic standoffs serve as "handles" to make removing the clips easier.
11. Attach the stray light shield (provided with the lens) to the top of the projector as
shown below.
12. Replace the front lens bezel.
13. Tighten the Phillips screw on the bottom of
the bezel to secure it.
Q-750i Series Installation/Operation Manual 21
Installation