Connections To The Ls-10D And Dhd Controller; Connector Panel Access - Runco LIGHTSTYLE LS-10D Installation & Operation Manual

Installation
3.6
Connections to the
LS-10d and DHD
Controller

Connector Panel Access

Proceed as follows to connect the DHD Controller to the LS-10d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
➤
Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Then, remove the rear compartment cover by
tilting it upward.
30 Runco LS-10d Installation/Operation Manual