Turning The Unit On And Off - Precor 9.33 Owner's Manual

Diagram 14
Diagram 15
CAUTION: Never remove or bypass the
3-prong plug on the unit's power cord with
an adapter. Do not use a non-grounded
outlet. Do not plug the treadmill into a
power transformer in an attempt to adjust
the voltage requirements.
Level
the
unit.
1
16. Level the unit. Diagram 14. The M9.33 has adjustable rear feet. Check to make
sure that the running surface is level (use a bubble level as shown in Diagram 14).
If the treadmill is placed on a slightly, uneven surface, adjusting the rear feet can
help, but will not compensate for extremely uneven surfaces.
Important: If you need to make adjustments, adjust one rear foot at a time. Do
not use the rear foot to raise or lower the unit more than ¾-inches. Check the
level of the unit after each adjustment.
Adjust the
rear deck.
17. Adjust the rear deck. Diagram 15. To raise the rear deck, insert the ¼-inch hex
key (G). Make sure that the key is fully engaged and turn it clockwise. Turning the
hex key counterclockwise lowers the unit.

Turning the Unit ON and OFF

Use the ON/OFF (I/O) power switch to turn the unit ON and OFF. This switch is
located on the front of the unit, near the power cord.
The treadmill requires a dedicated circuit. Plug the power cord into a dedicated
15 amp, grounded, power source. Make sure that no other product or machine
uses the same circuit as the treadmill.
To complete the installation of the treadmill, continue to Checking the Alignment of the
Running Belt on the next page .
2
page 17