Precor 9.33 Owner's Manual page 15

Diagram 10 Attach the handrails.
Handrail clamp
Loosen the four
handrail clamp
screws.
Side bracket
Screw (C) with
washer (E)
Lower portion of
handrail.
¾
with washers (D)
11. Attach the handrails. Diagram 10. To install the handrails, loosen the four
Diagram 11 Secure the the upper
handrail clamp.
Handrail clamp
Washer (D) with
screw (F)
Tighten the screws,
but leave room for
adjustments.
12. Install fasteners in the handrail clamp. Diagram 11. Return to the upper
1
3
-inch screws (C)
handrail clamp screws with the hex key provided. See Diagram 10, #1.
Attach one handrail at a time. Take the following steps on one side of the
treadmill and then, attach the opposite handrail.
a. Slide the end of the handrail into the handrail clamp. Diagram 10, #2.
b. Align the handrail with the side bracket. See Diagram 10, #3.
c. Have your assistant hold the handrail in place while you insert screw (C) with
washer (E) and secure the handrail to the side bracket. See Diagram 10, #3.
d. Attach the lower portion of the handrail. Diagram 10, #4. Align the lower end
of each handrail with the two base mount holes in the side rail. Place a
washer (D) onto each of two screws (C) and insert the screws. Finger tighten.
e. Perform steps a. through d. on the opposite side.
handrail clamp and place a washer (D) onto each of two screws (F). Thread the
screws through the handrail clamp. Finger tighten.
2
4
page 15