Setting Up The Treadmill; Installation Requirements; Assembly Instructions - Precor 9.33 Owner's Manual

2
CAUTION: Do not remove or otherwise
bypass the 3-prong plug with an adapter or
extension cord in order to use a non-
grounded outlet. Electrical damage can
occur if the treadmill is connected to an
improper power source.
CAUTION: Before assembling (or
disassembling) the unit, turn OFF the
treadmill and unplug it from the power
outlet. Do not assemble (or disassemble)
the treadmill if it is plugged into a power
source. To avoid injury and ensure your
safety, get assistance before lifting the
treadmill out of the box and rolling it onto
the floor. Do not drop the unit.
Diagram 3

Setting Up the Treadmill

You do not need any special knowledge or experience to set up the treadmill.
However, you will need assistance during assembly.

Installation Requirements

Follow these installation requirements when installing the treadmill. If you do not install the
treadmill according to the following guidelines, you could void the Precor limited warranty.
• Set up the treadmill on a solid, flat surface. Unpack and assemble the treadmill
close to where you plan to use it. Make sure that the surface under the unit is
smooth and level. A level unit is required for the user's safety and proper operation.
• Provide ample space around the unit. Open space around the unit makes for a
safer mount and dismount.
• Fill out and mail the limited warranty card. To locate the serial number, turn
OFF the treadmill. Place yourself at the rear of the treadmill and face the display.
Kneel down and look for the label on the inboard-side of the running bed at the
left, rear corner. Write the serial number onto warranty card found on the back
cover. Refer to Obtaining Service on page 9 and write the number there as well.
• Use the appropriate voltage, dedicated circuit, and grounding as specified on
the treadmill. The M9.33 treadmill requires a dedicated 15 amp circuit.

Assembly Instructions

To assemble the treadmill, take the following steps.
1. Obtain adult assistance. Have your assistants help place the shipping carton
close to the location where you plan to use the treadmill. Break down the side
walls of the shipping carton so that they lie flat. Remove the loose contents.
2. Make sure that the power switch is OFF. Check the ON/OFF power switch on
the front of the treadmill. Place the switch in the O (OFF) position. Make sure that
the treadmill is not plugged into a power source.
3. Move the treadmill. Diagram 3. To avoid injury to yourself or damage to the unit,
ask for help in placing the treadmill where you plan to use it. Diagram 3 illustrates
how to properly lift the rear end so that you can roll it on its front wheels.
Lift the rear of the
unit and roll it to its
assembly location.
Rear cover of unit
Lift rear by placing
hands on opposite
sides of the cross
brace that is found
under the rear cover.
page 11